FRAME1:

This test and the one which follows demonstrate two methods to solve a simple frame. Here, the frame is reduced via three reductions to a residual model which is solved and the results expanded.

• frame1 commands
• frame1 data
• frame1 log
• frame1 output

FRAME2:

Here, the frame is solved as a single system.

• frame2 commands
• frame2 data
• frame2 log
• frame2 output

FRAME3:

This is another simple frame test, showing the use of alias nodes.

• frame3 commands
• frame3 data
• frame3 log
• frame3 output

GAP:

The three gap tests check the operation of the gap and friction element. In this test, the first load case does not break the friction while the second one does.

• gap commands
• gap data
• gap log
• gap output

GAP2:

This test is a bit more complicated than the first one, but essentially the same.

• gap2 commands
• gap2 data
• gap2 log
• gap2 output

GAP3:

This test shows how one can perform two different stress analyses in the same run.

• gap3 commands
• gap3 data
• gap3 log
• gap3 output

INACTIVE:

This set of data illustrates how to perform several stress analyses with different elements inactive.

• inactive commands
• inactive data
• inactive log
• inactive output

INPLACE:

This set of data illustrates how to perform an inplace analysis of a fixed jacket. The structure is restrained through nonlinear soil/pile interaction. Twelve load cases are generated using four wave headings to the structure and two different wave heights. An operating environment and an extreme environment are explored using heavy and light deck loads.

• inplace commands
• inplace data
• inplace log
• inplace output

JLIFT:

This is a relatively small jacket being lifted. Instead of solving the problem in MOSES style, it is solved as if using a traditional structural analysis program. This sample shows how to use MOSES as if it were a simple structural program.

• jlift commands
• jlift data
• jlift log
• jlift output

PUNAPI:

This is a simple test of punching shear. It tests the -code option on the JOINT command.

• punapi commands
• punapi data
• punapi log
• punapi output

PUNTEST:

This is another test of punching shear.

• puntest commands
• puntest data
• puntest log
• puntest output

RESTEST:

This is a simple test of the input and reporting of restraints.

• restest commands
• restest data
• restest log
• restest output

SOLVE2:

This is a test of performing two structural solutions in the same run.

• solve2 commands
• solve2 data
• solve2 log
• solve2 output

SUBSTR:

This is an example of how to reduce, solve, and expand a structure.

• substr commands
• substr data
• substr log
• substr output

YLGAP:

This test illustrates the behavior of the gap element using a continuous beam, pinned on the ends, with the gap element support in the middle.

• ylgap commands
• ylgap data
• ylgap log
• ylgap output