Here, we discuss how to analyze the installation of a structure with MOSES. Each topic contains both a general discussion and specific examples. Most of the specific examples have common commands. To eliminate much repetition, these commands are discussed once and for all. If you have not done so, please click here to read the discussion.

General Discussion:

• Jacket Launch
• Transportation
• Lift, Lower, & Upending
• Loadout
• Mating
• Float Off

Automated Jacket Installation:

There are two examples of using the automated installation system. A jacket where loadout, transportation, launch, and upend simultations are performed in a single run and also a simple deck lift. This system is discussed in the reference manual. Click here for a general overview of the system, here for a discussion of the data template, and here for a discussion of the command file.

• Jacket Installation cif file
• Jacket Installation dat file
• Deck Lift dat file
• Deck Lift dat file

Specific Samples:

• Loadout Ballasting
• Manual Lift, Lower, & Upend
• Two Block Upend
• Mating a Jacket on a Hook